Coin capsules are sized to the coin's diameter in millimeters, so match the capsule to the published diameter of the exact coin. American Silver Eagles are 40.60 mm, Canadian Maple Leafs 38 mm, current Britannias 38.61 mm, Philharmonics 37 mm and Morgan or Peace dollars 38.1 mm. Use inert hard capsules or the original tubes for long-term storage, avoid soft PVC flips, and handle coins by the edges when loading.
Why capsule size matters
A capsule that is too large lets the coin move, which can cause rub marks on the high points and along the rim over time. A capsule that is too tight is hard to close and can scratch the coin or crack the holder as you force it. Getting the size right is cheap insurance for coins whose premium partly depends on clean surfaces.
Capsules are commonly labeled by the inner diameter in millimeters. Some brands use their own size codes, so always check the millimeter figure rather than a letter or model number. A few millimeters' difference between coins that look similar, such as a Maple at 38 mm and an Eagle at 40.60 mm, is enough to make a holder wrong.
Size table for common silver coins
Diameters below are published specifications from the issuing mints or standard references. Choose a capsule labeled for the same diameter, or the closest size the manufacturer recommends for that coin.
| Coin | Diameter | Notes |
|---|---|---|
| American Silver Eagle (1 oz) | 40.60 mm | Larger than most one-ounce coins |
| Canadian Silver Maple Leaf (1 oz) | 38 mm | Will rattle in an Eagle capsule |
| British Silver Britannia (1 oz, 2013 onward) | 38.61 mm | Older .958 issues (1997 to 2012) are 40.00 mm |
| Austrian Silver Philharmonic (1 oz) | 37 mm | Smallest of the common one-ounce sovereigns |
| Morgan or Peace dollar (classic 90%) | 38.1 mm | Thicker than many modern rounds |
| Half dollar (Walking Liberty, Franklin, Kennedy) | 30.6 mm | Same diameter for 90% and 40% halves |
| Quarter (Washington) | 24.3 mm | Junk silver usually stored in rolls, not capsules |
| Dime (Mercury, Roosevelt) | 17.9 mm | Usually rolled or bagged |
Generic one-ounce rounds vary by private mint. Many are close to 39 mm, but measure yours with calipers or check the mint's product page before buying holders in bulk. Thickness matters too: some capsules accommodate thicker coins better than others.
Capsules, tubes, flips and slabs
| Holder | Best for | Watch out for |
|---|---|---|
| Hard round capsule | Individual display coins, gifts, better-condition pieces | Correct size; some use foam ring inserts to fit several sizes |
| Original mint tube | Bulk one-ounce coins of one type | Tube counts differ: Eagles 20, Maples 25 |
| Generic coin tube | Rounds and coins without mint tubes | Tube diameter must match the coin |
| Cardboard 2x2 with Mylar window | Inexpensive single-coin storage, labeling | Staples can scratch neighboring coins |
| Soft plastic flip | Short-term handling only | Some soft flips contain PVC, which can damage surfaces over time |
| Third-party grading slab | Certified numismatic coins | Not needed for bullion; adds cost |
For bulk bullion, the original mint tube is usually the best holder: it is the right size, it is what buyers expect, and it makes counting easy. Capsules make the most sense for individual coins you will display, gift or handle often. The tube count guide explains why tubes hold different numbers of coins.
Avoid PVC for long-term storage
Polyvinyl chloride (PVC) makes plastic soft and flexible, which is why older or cheaper flips feel pliable. Over time, PVC can leave a residue on coins that appears as a green or hazy film and can damage surfaces. Inert materials such as hard acrylic-type capsules, Mylar and polyethylene are generally preferred for storage. If you are unsure what a holder is made of, choose a product that explicitly states it is PVC-free or archival-safe. The surface conditions guide explains other causes of discoloration.
How to load a capsule without marking the coin
- Work over a soft cloth or towel in case a coin slips.
- Wear clean cotton or nitrile gloves, or hold the coin only by its edge.
- Do not breathe or talk directly over the coin's surface.
- Seat the coin in one half of the capsule (or in the ring insert) and close the other half gently and evenly.
- If it will not close without force, stop; the size is wrong.
- Label the capsule's storage box, not the capsule itself, to avoid adhesives near the coin.
How to measure a coin you are unsure about
When you cannot find a published spec, or you want to confirm a generic round, measure it. Digital calipers are inexpensive and accurate enough for choosing holders. Close the jaws gently across the widest point of the coin, measuring rim to rim, and take two or three readings at different angles. Note the thickness too, especially for high-relief or thick rounds, because some capsules have limited depth.
If your measurement falls between two capsule sizes, many manufacturers publish a fit guide or recommend a specific size for common coins. Ring-insert capsules, which use a foam or plastic ring to hold the coin centered, can accommodate several diameters with one outer shell and are useful when you store a mix of coin sizes.
Labeling and organizing capsuled coins
Capsules make individual coins look neat, but a pile of loose capsules is hard to inventory. Store capsuled coins in boxes or trays designed for them, and label the box or tray slot rather than the capsule. A simple slot map, such as "Tray 1, row A: 2026 Maples," lets you find and count coins without handling each one. Record the same information in your inventory spreadsheet so a buyer or family member can see what is there.
- Keep one coin type per tray or tube.
- Add desiccant to closed boxes and replace it periodically.
- Keep trays flat so capsules do not shift and rub.
- Photograph trays when you finish organizing.
Holders at bulk scale
Capsules cost money, and on cheap bullion the holder can be a meaningful share of the premium per coin. For a stack of hundreds of coins, mint tubes or generic tubes are usually more practical and cheaper per coin. Reserve capsules for the coins where presentation or surface condition matters. Also consider space: a capsule adds diameter and thickness, so a box of capsuled coins takes more room than the same coins in tubes. The storage space guide and tube weight guide help with planning.
Selling coins in capsules
Buyers of bullion coins generally do not pay extra for capsules, and some will remove coins to inspect them. Keeping coins in original tubes or properly sized capsules mainly protects condition, which can protect the bid. For condition-sensitive coins, the rounds vs bars selling guide explains why buyers look harder at coin surfaces.
Check more than one dealer shelf
A useful comparison starts with the same product size, quantity tier and payment method. The dealer review pages below are the stable jump-off points; current inventory and final checkout totals remain the source of truth.
Affiliate links on dealer pages may earn BulkSilver.co a commission without changing your price.
Use the existing BulkSilver tools
Frequently asked questions
What size capsule does an American Silver Eagle need?
A capsule for a 40.60 mm coin. The U.S. Mint lists the bullion Silver Eagle at 40.60 mm in diameter.
What size capsule fits a Silver Maple Leaf?
A capsule for a 38 mm coin. The Royal Canadian Mint lists the one-ounce Silver Maple Leaf at 38 mm.
Do Morgan dollars fit Silver Eagle capsules?
Not properly. Morgan and Peace dollars are 38.1 mm, while Eagles are 40.60 mm, so a Morgan will move in an Eagle capsule.
Are soft plastic coin flips safe for silver?
Some soft flips contain PVC, which can damage coin surfaces over time. Use PVC-free, inert holders for long-term storage.
Is it better to store silver coins in capsules or tubes?
For bulk bullion, original or properly sized tubes are usually more practical and cheaper per coin. Capsules suit individual coins you display, gift or handle often.